Toro Z Master 74916 User Manual (English)

Questions and Answers:

P
patrick18Aug 22, 2025
What to do if my Toro Lawn Mower blades do not rotate?
- O
  osilvaAug 22, 2025
  If the blades on your Toro Lawn Mower do not rotate, the mower deck belt might be worn, loose, or broken, so install a new deck belt. The mower deck belt might be off the pulley, so install the mower deck pulley and check the idler pulley, idler arm, and spring for correct position and function. The pump drive belt might be worn, loose, or broken, so check the belt tension or install a new belt. Finally, the idler spring might be broken or missing, so replace it.
J
Jennifer GarciaAug 25, 2025
What to do if my Toro Z Master 74916 Lawn Mower does not drive?
- P
  Penny ThompsonAug 26, 2025
  If your Toro Lawn Mower does not drive, the bypass valves might not be closed tight, so tighten them. The pump belt might be worn, loose, or broken, so change the belt. The pump belt might be off a pulley, so change the belt. The idler spring might be broken or missing, so replace the spring. The hydraulic oil level might be low or too hot, so add hydraulic oil to reservoirs or let it cool down.
J
Jessica SmithAug 28, 2025
What to do if my Toro Lawn Mower starter does not crank?
- D
  Donald BryantAug 28, 2025
  If the starter on your Toro Lawn Mower doesn't crank, it could be due to several reasons: * The blade control switch (PTO) might be engaged; disengage it. * The parking brake might not be on; set it. * The drive levers might not be in the neutral lock position; ensure they are. * You might not be seated; sit on the seat. * The battery could be dead; charge it. * Electrical connections might be corroded or loose; check them for good contact. * A fuse might be blown; replace it.
G
Gary ScottAug 31, 2025
What to do if my Toro Z Master 74916 engine loses power?
- L
  Luis MunozAug 31, 2025
  If your Toro Lawn Mower engine loses power, it could be due to several reasons. The engine load might be excessive, so reduce the ground speed. The air cleaner might be dirty, so clean the air cleaner element. The oil level in the crankcase might be low, so add oil to the crankcase. The cooling fins and air passages above the engine might be plugged, so remove the obstruction. The vent hole in the fuel cap might be plugged, so clean or replace the fuel cap. There might be dirt in the fuel filter, so replace the fuel filter.
W
William WoodSep 3, 2025
Why is my Toro Lawn Mower vibrating abnormally?
- S
  Susan GonzalezSep 3, 2025
  Abnormal vibration in your Toro Lawn Mower can stem from several issues. The cutting blade(s) could be bent or unbalanced, so install new ones. The blade mounting bolt might be loose, so tighten it. The engine mounting bolts could be loose, so tighten them. A loose engine pulley, idler pulley, or blade pulley could be the cause, so tighten the appropriate pulley.
C
Carl MorenoSep 6, 2025
What to do if my Toro Lawn Mower engine overheats?
- C
  Carrie RobinsonSep 6, 2025
  If your Toro Lawn Mower engine overheats, it could be due to a few reasons. The engine load might be excessive, so reduce the ground speed. The oil level in the crankcase might be low, so add oil to the crankcase. The cooling fins and air passages above the engine might be plugged, so remove the obstruction from the cooling fins and air passages.
S
staceycarsonSep 9, 2025
Why does my Toro Z Master 74916 Lawn Mower pull left or right?
- M
  Margaret PerrySep 9, 2025
  If your Toro Lawn Mower pulls to the left or right, it may be because the tracking needs adjustment, so adjust the tracking. Alternatively, the tire pressure in the drive tires may not be correct, so adjust the tire pressure.