Toro Z Master 8000 Series - Checking the Hydraulic Fluid

10
CheckingtheHydraulic
Fluid
NoPartsRequired
Procedure
Themachineisshippedwithhydraulicuidinthe
reservoir.
1.Checkandensurethereservoirhashydraulic
uid.
2.IfneededaddToroHYPR-OIL™500hydraulic
uid.
3.Runthemachineforapproximately15minutes
toallowanyextraairtopurgeoutofthehydraulic
system.
4.Waituntilthemachinecoolsbeforecheckingthe
hydraulicuid.
5.Tiltthehopperup.
6.Removethehydraulicreservoircap.
7.Wipethedipstickcleanandinsertthecapback
intothehydro.
8.Lightlytightenthecap.
9.Removethecapagainandcheckthelevelof
theuidonthedipstick(Figure18).
10.Checkthehydraulicreservoirandifnecessary
llthereservoirtotheappropriatelevelwithToro
HYPR-OIL™500hydraulicuid.
g026291
Figure18
1.Full2.Add
11.IfthedipstickuidlevelisattheAddmark,add
hydraulicuid.Donotoverll.
12.Replacethehydraulicreservoircapandtighten
untilsnug.Donotovertighten.
11
CheckingtheMachinefor
Grease
Partsneededforthisprocedure:
1tube
No.2lithiumgrease(Purchaseseparately.)
Procedure
Beforeyouusethemachine,checkthemachinefor
grease;refertoLubricationintheOperator'sManual.
10