Toro Z355 Z-Master - Page 22

22
9. Remove shoulder bolts (3/8 x 7/8 inch) and locknuts
(3/8 inch) securing spring end plate assemblies to
carrier frame (Fig. 24).
1
m–3209
3
2
Figure 24
1. Spring assembly
2. Shoulder bolt, 3/8 x
7/8 inch
3. Locknut, 3/8 inch
10. Remove the block under the carrier frame.
11. Tilt carrier frame down.
12. Remove the two nuts and bolts that hold the bar for
rubber guard. The bar is under the motion control
levers. Fold the rubber guard onto the footrest (Fig.
25).
5
4
1
2
m–4858
3
Figure 25
1. Bar
2. Rubber guard
3. Nut
4. Machine panel
5. Screw
13. Remove hairpin cotters and pivot pin assemblies from
push arms at traction unit pivot brackets (Fig. 26).
Note: Save all hardware for use when installing mower.
Items 3 and 4 are part of traction unit.
2
4
3
m–4870
1
Figure 26
1. Pivot bracket
2. Push arm
3. Pivot pin assembly–flat
4. Hairpin cotter
Note: Drive shaft remains with traction unit.
14. Drive roll pin through hole in PTO drive shaft to
separate from gearbox shaft (Fig. 27).
1
2
4
3
M–4532
Figure 27
1. PTO drive shaft
2. Universal joint
3. Gearbox shaft
4. Roll pin
15. Move deck and carrier frame away from traction unit.
Important Remove drive shaft from gearbox shaft if
you do not hook up a deck immediately or when putting
on optional attachments.
16. Remove 2 bolts (3/8 x 1-5/8 inch) and locknuts (3/8
inch) from universal joint and slide the drive shaft off
gearbox shaft (Fig. 28).