EasyManua.ls Logo

Toro Z453 Z Master - Servicing the Engine Oil

Toro Z453 Z Master
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Servicing the Engine Oil
Service Interval/Specication
Chang e the engine oil as follo ws:
After the first 8 operating hours
After ev er y 100 operating hours
Note: Chang e the oil more frequently when
the operating conditions are extremely dusty
or sandy .
Oil T ype: Deterg ent oil (API ser vice SF , SG ,
SH, or SJ)
Crankcase Capacity: 58 ounces (1.7 liter) with
the filter remo v ed; 51 ounces (1.5 liter) without
the filter remo v ed
Viscosity: R efer to the table belo w
Figure 33
Checking the Engine Oil Level
1. P ark the mac hine on a lev el surface .
2. Diseng ag e the PTO , tur n the ignition k ey to
off , and remo v e the k ey .
3. W ait for all mo ving par ts to stop before lea ving
the operating position and then c hoc k or bloc k
tires .
4. Clean around the oil dipstic k ( Figure 34 ) so
that dir t cannot fall into the filler hole and
damag e the engine .
Figure 34
1. Oil dipstick 2. Filler tube
5. Unscrew the oil dipstic k and wipe the end
clean ( Figure 34 ).
6. Slide the oil dipstic k fully into the filler tube ,
but do not thread onto tube ( Figure 34 ).
7. Pull the dipstic k out and look at the metal end.
If the oil lev el is lo w , slo wly pour only enough
oil into the filler tube to raise the lev el to the
Full mark.
Important: Do not o v erfill the crankcase
with oil and r un the engine; engine dama ge
can r esult.
Changing the Oil
1. Star t the engine and let it r un fiv e min utes .
T his w ar ms the oil so it drains better .
2. P ark the mac hine so that the drain side is
slightly lo w er than the opposite side to assure
the oil drains completely .
3. Diseng ag e the PTO and set the parking brak e .
4. Stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.
5. Slide the drain hose o v er the oil drain v alv e .
6. Place a pan belo w the drain hose . R otate oil
drain v alv e to allo w oil to drain ( Figure 35 ).
7. W hen oil has drained completely , close the
drain v alv e .
8. R emo v e the drain hose ( Figure 35 ).
Note: Dispose of the used oil at a recycling
center .
30

Table of Contents

Related product manuals