Why Toro Z555 74245 Lawn Mower starter does not crank?
K
Kelli GrimesAug 1, 2025
Your Toro Lawn Mower's starter might not crank due to several reasons:
* The blade control (PTO) might be engaged, so disengage it.
* The parking brake may not be set; engage the parking brake.
* You may not be seated, so sit on the seat.
* The battery could be dead, requiring a charge.
* Electrical connections might be corroded or loose, check them.
* A blown fuse could be the issue, replace it.
* A defective relay or switch.
J
Jamie JohnsonAug 6, 2025
How to fix uneven cutting height on Toro Z555 74245?
R
Ricky TaylorAug 6, 2025
To address an uneven cutting height on your Toro Lawn Mower, take these steps:
* Sharpen the blade(s) if they are not sharp.
* Install new cutting blade(s) if the current ones are bent.
* Level the mower from side-to-side and front-to-rear.
* Adjust gage wheel height if the anti–scalp roller is not set correctly.
* Clean the underside of the mower if it is dirty.
* Adjust tire pressure if it is incorrect.
D
Danielle GonzalezAug 11, 2025
What to do if Toro Z555 74245 does not drive?
W
wrightkennethAug 11, 2025
If your Toro Lawn Mower does not drive:
* Add hydro fluid to reservoir if hydro fluid level low.
* Connect the tension spring if it is not connected.
S
Sarah LewisAug 16, 2025
What to do if Toro Lawn Mower engine loses power?
A
Amy HarrisAug 16, 2025
If your Toro Lawn Mower engine loses power, consider the following:
* Reduce ground speed if the engine load is excessive.
* Clean the air cleaner element if it's dirty.
* Add oil to the crankcase if the oil level is low.
* Remove any obstructions from the cooling fins and air passages under the engine blower housing.
* Install new, correctly gapped spark plugs if the current ones are pitted, fouled, or have an incorrect gap.
* Open the vent in the fuel cap if it is closed.
* Replace the fuel filter if it's dirty.
Q
qwoodsAug 21, 2025
What to do if Toro Z555 74245 has abnormal vibration?
B
Benjamin CollinsAug 21, 2025
If your Toro Lawn Mower is experiencing abnormal vibration, check the following:
* Install new cutting blade(s) if the current ones are bent or unbalanced.
* Tighten the blade mounting bolt if it's loose.
* Tighten the engine mounting bolts if they are loose.
* Tighten the appropriate pulley if the engine pulley, idler pulley, or blade pulley is loose.
H
Heidi VillarrealAug 27, 2025
What to do if Toro Lawn Mower blades do not rotate?
M
Michele BurnsAug 27, 2025
If the blades on your Toro Lawn Mower do not rotate:
* Install the mower belt and check the adjusting plate, idler arm and spring, and belt guides for correct position, if the mower belt is off the pulley.
* Install a new mower belt if the current one is worn, loose, or broken.