18
5-Bluetooth Pass: In case you want additional protection for your controller, enter a
Bluetooth password, which can be found on the controller`s label. Bluetooth pass
will be required every time you will connect to the App with a new device.
6-Scan Bluetooth: Use it for connecting to your device.
7-Error: The list of all controller errors since the last time it was disconnected from
the battery. This list is useful in determining the causes for controller
malfunctioning.
8-Update Firmware: Check whether a new Firmware is available. In case it is, press
the button to update.
9-Ride log: You can check your ride on the map or send your ride-log file with all the
stats to the chosen email address.
10-Measure Time: Measure the acceleration of your e-bike.
11-Diagnostics: An overview of all technical characteristics of the Controller that can
help with determining the cause of potential errors.
12-Calibration: IMPORTANT: Calibration must be done before each first use of the
controller and after each firmware update! Click on the calibration button and
follow the wizard to calibrate the motor and throttle.
13-Reset to Factory Defaults: Reset your controller to the factory settings. By
pressing this button you will lose all the settings you have made previously. After
you reset your controller to the Factory Defaults, you will need to re-calibrate the
throttle and HALL Sensors.
14-Advanced: Press this button for some additional settings regarding CURRENT,
FIELD WEAKENING, and THROTTLE.
WWW.TORPMOTORS.COM
To Next Page
Loading...