13 14
1.Please turn off the product first when cleaning and
maintaining this product. Clean it with wet paper towels.
Or with a soft cloth with a little medical alcohol (alcohol
concentration of 75%) for wiping and disinfecting if it is
too dirty ;
2.During daily maintenance, please use a neutral
detergent and a soft cloth to wipe. Do not uscorrosive
cleaning agents. Do not put it in water to soak or rinse.
Do not flush it with water.
3. During the cleaning process, please prevent water or
other liquids from flowing into its body of it to avoid the
risk of short circuits or electric shock when using.
Warning: This product MUST not contact with
chemicals such as disinfecting liquid, industrial alcohol,
cleaning solution, and other daily-use strong alkali and
strong acid chemicals.
Attentions
Important notice: save for future use. It should not be
used by people who cannot take care of themselves,
infants or people who are not sensitive to heat.
1. This product should not be used by children under
the age of 10 alone, unless the parent or guardian
has set the product in advance, or has guided the
children about how to use the product.
2. Do not use this product for strollers.
3. Do not put your fingers or any other objects into the
protective net when the product is working, to prevent injury.
Battery Warning
This product is equipped with a built-in lithium battery, and
please pay attention to the followings:
1. To extend the battery life, it is recommended to fully
charge before use the product for the first time.
2. Please charge the product in time when the battery is
low. To protect the battery, please turn on the product
every 3 months until the battery power runs out and
then fully charge the product, when not in use for a
long time. It is recommended to use and store it in a
suitable environment.
3. Do not disassemble, impact, extrude, or throw it into the
fire. Do not continue to use it if it is inflated severely. Do
not place it in a high-temperature environment. Do not
continue to use it and have it repaired by professionals if
the battery life is seriously shortened.
4. There is a risk of explosion if the battery is improperly
replaced, and it can only be replaced with a battery of
the same or equivalent type by a professional.
5. The battery (battery pack or assembled battery) shall
not be exposed to overheated environments such as
sunlight or fire.
6. Products containing lithium batteries should be handled
separately from household waste. If the product is
disposed of, it is necessary to remove the battery
and insulate the positive and negative ends and put it
into the designated recycling locations or hand it over to
the environmental protection recycling department for
disposal, and cannot discard it at will.
7. Steps to remove the battery:
① Remove the screw cover on the right side, and the
screws with a screwdriver, then remove the front
decorative cover; ② Pry the upper and lower shells with
a screwdriver, then remove the screws of the circuit
board with a screwdriver; ③ Unplug the battery socket
to take out the battery; ④ Remove the left battery in the
same way. (Special warning: Do not cut off all the
cables between the battery and the circuit board at the
same time.)
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment. This
equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV
technician for help
This device complies with part 15 of the FCC rules.
To Next Page
Loading...