Need help?Do you have a question about the Toshiba 21N21B2 and is the answer not in the manual?
Safety notices indicated with labels or seals on the chassis.
Warning about high voltage parts inside the equipment.
Use specific parts with correct characteristics for safety.
Caution regarding potential implosion hazard from CRT.
Safety measures to prevent X-ray emission from high voltage circuits.
Importance of post-service safety checks, including insulation testing.
Step-by-step guide for removing the anode cap safely.
Procedures for safely installing the anode cap.
Procedures for removing and installing flat package ICs.
List of service modes accessible via set keys and remote control.
Steps for replacing the memory IC and setting initial data.
Steps to perform adjustments when repairing circuits or replacing parts.
Adjusting DC voltage to 117 ± 0.5V.
Adjusting coarse and fine VCO settings.
Adjusting AGC voltage to 2.4 ± 0.05V.
Adjusting screen volume for a dim raster.
Initial rough adjustment of convergence using magnets.
Centering and equalizing colors using purity magnets.
Fine-tuning convergence using 4 and 6 pole magnets.
Adjusting convergence by moving the deflection yoke.
Schematic of the Microcomputer IC, tuner, and related components.
Schematic of the IF/Chroma IC and its supporting components.
Schematic of the Sound Amplifier IC and its supporting components.
Schematic of the Vertical Drive IC and its supporting components.
Schematic for horizontal output transistors and drive stages.
Schematic showing connections to the CRT and bias circuits.
Schematic of the power supply control IC and feedback loop.
Schematic of the switching transistor and its driving components.
Schematic of voltage regulators for stable power output.
List of resistors with their location, part number, and value.
Further continuation of the resistor list with part details.
List of capacitors with their location, part number, and value.
Further continuation of the capacitor list with part details.
To Next Page
General
