28
Using the TV’s features (General)
REGZA-LINK Controls
This feature uses CEC (Consumer Electronics Control)
technology, and allows the control of Toshiba REGZA-
LINK compatible equipment from the television’s remote
control.
Note: Not all Toshiba products currently support REGZA-
LINK.
Equipment Control
The REGZA-LINK mode on the television’s remote
control allows the control of connected REGZA-LINK
equipment being watched.
To control the REGZA-LINK input source, first select the
equipment with REGZA-LINK input source selection,
then switch the mode on the remote control to REGZA-
LINK and press any buttons.
The available functions are dependent on the equipment
connected. Not all the remote control keys may be
available. Please refer to the operation manual for each
piece of equipment connected.
Note: The television features that can be controlled
by the connected equipment are: Standby, Volume,
Channel, Sound Mute, Display Information, Number
Buttons and Previous Programme.
Input Source Selection
When any equipment using CEC technology is
connected, the REGZA-LINK icon will appear in the input
source list allowing selection of individual devices.
1. Press . A list will appear on screen showing
modes and all stored external equipment.
Main
TV
1
2
3C
HDMI 1
HDMI 2
HDMI 3
HDMI 4
PC
4C
2. The REGZA-LINK icon appears automatically after
detected with REGZA-LINK compatible equipment.
Press ▼ to highlight the input source shown with the
REGZA-LINK icon.
Main
TV
1
2
3C
HDMI 1
HDMI 2
HDMI 3
HDMI 4
PC
4C
REGZA-LINK
3. Press ►. A second selection screen will appear
showing all connected REGZA-LINK equipment.
4. Press ▲ or ▼ to highlight an input source, and then
press
to select.
Note 1: When the television is switched on, it will take a
few minutes for the REGZA-LINK icon to appear in the
list, when an HDMI cable is removed, it will take a few
minutes for the logo to disappear.
Note 2: If the HDMI cable from the connected equipment
is changed, or HDMI equipment settings are changed,
the Enable REGZA-LINK in the REGZA-LINK setup
menu may need to be reset to On.
Note 3: When the REGZA-LINK input source is selected,
some REGZA-LINK equipment may automatically switch
on.
The following features are dependent on the connected
equipment. For operating information, refer to the
operation manual for all connected equipment.
Pass-Through Control
The Pass-Through feature allows you to control the
connected REGZA-LINK device by the television’s
remote control.
1. Press ▲ or ▼ to select REGZA-LINK in the Quick
Access Menu, and then press OK. The control panel
will appear.
When there are two or more REGZA-LINK devices
connected to the television, a device selection menu
will appear. Highlight the device you want to control,
and then press
to select.
GUIDE EXIT
MENU
MENU
CONTENTSROOT TOP DVD
RETURN
To Next Page
Loading...
Need help?
General
