English - 39 -
(**) Limited Models Only
If you carried out the setup after the first time instal-
lation you will return to the first screen of the setup
wizard when you press OK. In that case press Exit
or highlight Setup Later and press OK in order to
exit the setup.
Once the setup is complete, you will be able to control
the functions of your TV with Alexa.
Note: Make sure that the devices are connected to the internet.
Interacting with Alexa
To activate Alexa and make it listen what you are
saying, just say “Alexa”. You can also press and
hold the Language button on the remote for about 3
seconds to do that. When Alexa is activated its logo
will appear on the lower right corner of the TV screen.
You can press the Exit button on your TV remote to
end the Alexa’s response to your request.
Press and hold the Mute button on the remote for
about 3 seconds to turn off the microphones. Press
and hold the button again to turn on the microphones.
Standby Mode LED Status
The embedded microphone will affect the Standby
Mode Led status of your TV as follows:
TV Power State
Microphone
State
Standby Mode
LED Status
Mode
Not lit
On On Green
On Red
Mode
On Red
Example Commands
Here are some voice commands that you can use to
control the functions of your TV with Alexa:
Command Function
Alexa, turn on ‘FN’ Powers on the TV
FN’
Alexa, play ‘FN’ Starts media playback
Alexa, pause ‘FN’ Pauses media playback
Alexa, resume ‘FN’ Resumes media playback
Alexa, stop ‘FN’ Stops media playback
Alexa, fast forward on ‘FN’
Advances media in fast
forward mode
Alexa, rewind on ‘FN’ Rewinds media
Alexa, set the volume of
‘FN’ to 50
Sets the volume to the
Alexa, turn the volume up
on ‘FN’
Increases volume by 10
units
Alexa, turn the volume
down on ‘FN’
Decreases volume by
10 units
Command Function
Alexa, mute ‘FN’ Mutes sound
Alexa, unmute ‘FN’ Unmutes sound
Alexa, change the input to
“input_name” on ‘FN’
The TV switches to the
input source with the spec-
Alexa, change channel to
"channel_number" on ‘FN’
The TV switches to the
number (e.g., channel
200)
Alexa, change channel to
“channel_name" on ‘FN’
The TV switches to the
name
Alexa, channel up on ‘FN’
The TV switches to the
next higher channel, if any
available
Alexa, channel down
on ‘FN’
The TV switches to the
next lower channel, if any
available
Alexa, next channel on
‘FN’
The TV switches to the
next channel on the
channel list
FN is the abbreviation for ‘Friendly Name’.
DVD Mode (**)
Safety Information
CAUTION
DVD Player is a class 1 laser product. However this
product uses a visible laser beam which could cause
hazardous radiation exposure. Be sure to operate the
player correctly as instructed.
CLASS 1
LASER PRODUCT
RISK OF ELECTRIC SHOCK
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated “dangerous voltage” within the
product’s enclosure that may be of sufficient magnitude
to constitute a risk of electric shock of persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
Notes on Discs
On handling discs
To keep the disc clean, handle the disc by its edge.
Do not touch the surface.
Do not stick paper or tape on the disc.
To Next Page
Loading...
