Using the remote control
Preparing the remote control for use
"l_e remote control will operate your'l_V, most VCR models, and
most cable "I_V converters together, even if they are different brands.
• If you will be using your TV with a "lbshiba VCR or cable "FV
converter, your remote control is already programmed and ready
m use. See "Using the remote control with a "lbshiba VCR or
cable TV converter" below.
• If you own a non:lbshiba VCR or converter ,'rod,_ant to use your
"FV remote control to operate it, you will need to program the
remote control. See "Programming the remote control _)r use
with a non:lbshiba VCR or cable "I_Vconverter" on page 13.
Installing the remote control batteries
To install the batteries:
1. Slide the battery cover off the back of the remote control.
oo(IIID
Note:
Theremote controlprovided with your TV
may or maynot operate certainfeatureson
your VCFLcable TVconverter,or other
electronicequipment. Refer to the owner's
manualsprovided with your other equipment
tosee which featuresare available.In
addition, the other remote controls mayhave
buttons not availableonyour TV'sremote
control,lf you wouldlike to usethose features
or buttons,you may need to use the original
remote controlsprovided withyour other
equ@ment.
Caution:
. Dispose ofbatteries in a designated
disposalarea.Do not throw batteries
into a fire.
. Do not mix battery typesor combine used
batterieswith new ones.
. Remove deadbatteriesimmediately to
preventbattery acid from leaking into the
battery compartment.
. If you do not intend to usethe remote
controlfor a tong time, remove the
batteries.
2. Install two "AA" size batteries. Match the + mad - symbols on
the batteries to the symbols on the battery compartment.
©
©
3. Slide the battery cover back Ohm the remote control until the
lock snaps.
Using the remote control with a Toshiba VCR
or cable TV converter
To control a Toshiba VCR:
Set the TV/CABLE/VCR switch to the VCR position. The
shaded buttons in the illustration at right will then control the
VCR. The unshaded buttons will operate the "I_Vas usual.
To control a Toshiba cable TV converter:
Set the TV/CABLE/VCR switch to the CABLE position. The
shaded buttons in the top portion of the illustration at right will
then control the cable "I_Vconverter.
TOSHIBA
CT-90037
--CHANNEL
NUMBERS
(Used for the
"Enter" command with
some VCRs and cable
TV converters
CHANNELAY
TV/CABLE/VCR
switch
VCR buttons (set
TV/CABLE!VCR
switch to "VCR")
12
To Next Page
Loading...
