To allocate a programme position on the television for a decoder and media recorder: turn the
decoder on, insert a pre-recorded film in the media recorder and press PLAY, then manually
tune.
Programme :The number to be pressed on the remote control.
System :Specific to certain areas.
Colour system :Factory set to Auto, should only be changed if problems are
experienced, i.e. NTSC input from external source.
Programme skip :
means nothing has been stored or the facility to skip the
channel is ON.
Channel :The channel number on which a station is being broadcast.
Search :Search up and down for a signal.
Manual fine tuning:Only used if interference/weak signal is experienced.
Station :Station identification. Use up or down and left or right to enter up
to seven characters.
To Next Page
Loading...
