– 15 –
GENERAL ADJUSTMENTS
SPECIFIC INFORMATIONS
PROGRAMMING CHANNELS INTO THE TV'S MEMORY
When you press CHANNEL s t on the TV or remote control, the TV stops only on the channels stored in the TV's memory.
Note: To tune the TV to a channel not programmed into the meomory, use the CHANNEL NUMBERS on the remote control.
Follow the steps below to program channels into the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your
area and store them in the TV's memory. After the channels
are stored automatically, you can manually add or erase indi-
vidual channels.
To program channels automatically:
1
Press MENU.
2
Press T or S to highlight the SET UP menu.
3
Press s or t to highlight TV/CABLE.
4
Press T or S to highlight TV (if you use an antenna) or
CABLE (if you use cable).
5
Press t to highlight CH PROGRAM.
6
Press T or S to start automatic channel programming ("CH
PROGRAM" displays on-screen). The TV automatically
cycles through every TV or cable channel (depending on
which you selected), and stores all active channels in the
TV's memory.
7
When automatic channel programming is complete, the
message "CH Programming Completed" appears.
8
Press CHANNEL s t to view the programmed channels.
Adding and erasing channels manually
After you have automatically programmed the channels into
the TV's memory, you can manually add and erase individual
channels.
To add a channel to or erase a channels from the TV's
memory:
1
Tune the TV to the channel you want to add or erase. If you
are adding a channel, you will need to use the CHANNEL
NUMBERS to select the channel.
2
Press MENU.
3
Press T or S to highlight the SET UP menu.
4
Press s or t to highlight ADD/ERASE.
5
Press T or S to highlight ADD or ERASE, whichever func-
tion you want to perform.
6
Press MENU.
7
Repeat steps 1-6 for other channels you want to add or
erase, or press EXIT to return to normal TV viewing.
Changing channels:
To change to the next programmed channel:
Press CHANNEL s t.
To change to a specific channel (programmed or
unprogrammed):
Press the CHANNEL NUMBERS (0-9 and 100).
Note: For channels 100 and higher, press the 100 button, and
then the next two channel numbers (for examle, to select chan-
nel 100, press 100, 0, 0; to select channel 125, press 100, 2,
5).
To Next Page
Loading...
