Initial Setup and Menu
61
Volume Control
1 Use the
t
/
u
(arrow) buttons
to set up the Volume control to
select:
❖
TV (this is the default)
❖
External
The Volume + or – and MUTE buttons will control the
external equipment through the IR blaster.
2 Press the OK button.
Press the OK button on the IR Blaster Setup complete screen.
Support Information screen will appear.
Guide Preferences
1 Use the
t
/
u
(arrow) buttons
to set up the Guide preferences
to select:
❖
TV MediaGuide
❖
External Device Guide
2 Press the
q
(arrow) button to select Interval Time.
❖
0.125 sec
❖
0.25 sec
❖
0.375 sec
❖
0.5 sec
❖
0.625 sec
❖
0.75 sec
❖
0.875 sec
❖
1 sec
❖
After the interval time is selected, press the RED button to
show the Test screen. The test will start automatically.
3 Press the OK button.
Press the OK button on the IR Blaster Setup complete screen.
Support Information screen will appear.
8 Support Information
Read through the information, and press the OK button.
❖
The initial setup is completed.
NOTE
Refer to this information if there is a problem and you need to contact
Customer Support. To find help, the following operation can be performed
at any time. SETUP button > Get Help > System Information > OK
button.
Performing the initial setup
To Next Page
Loading...
Need help?
General
