Switchingbetweentwo channelsusing
ChannelReturn
The Channel Return feature allows you to switch between two
channels without entering an actual channel number each time.
1 Select the first channel you want to view.
2 Select a second channel using the Channel Number
buttons (and the dash ((_D) button if selecting a digital
channel).
Pr ssC"RT"
e_ O on the remote control. The previous channel
will display. Each time you press c_T, the TV will switch
back and forth between the last two channels that were
tuned.
OH RTN
Note: Ifyou press 0 from a non-antenna input, the TV
will return to the last-viewed input.
Switchingbetweentwo channelsusing
SurfLeckTM
The SurfLock TM feature temporarily "memorizes" one channel
to the C_TNbutton, so you can return to that channel quickly
r ssin c,,T,
from any other channel Dyp e_ g O . To memorize a
channel to the c_T, button:
1 Tune the TV to the channel you want to program into the
CH RTN
o button.
Press and hold c_T, for about 2 seconds until the message
"Memorized" appears on-screen. The channel has been
programmed to the C_T.button.
3
You can then change channels repeatedly, and when you
press C_TN,the memorized channel will be tuned.
The TV will return to the memorized channel one time only.
r ss CH RTN n"
Once you p e_ O a d then change channels again, the CH
RTN memory will be cleared and the button will function as
Channel Return, by switching back and forth between the
last two channels that are tuned.This feature also works for
external inputs.
Selectin9 the picture size
You can view many program formats in a variety of picture
sizes--Natural, TheaterWide 1, TheaterWiae2, TheaterWide
3, Full, 4:3 ND, Native and DOt by DOt(available in PC Mode
Only).
Note: The "picture size" illustrations are examples only. The
format of the image (in any of the picture sizes) will vary
depending on the format of the signal you are currently
watching. Select the picture size that displays the current
program the way that looks best to you.
You can save separate picture size preferences for each input
on your TV.
To select the picture size using the remote control:
1 Press p,c_,zEon the remote control.
While the Picture Size screen is open, you can do one of
the following to select the desired picture size:
R "l r ssP_cs'zE
• epeated yp e_ o .
• Press the corresponding Number button (0-6) while the
Picture Size screen is open.
• Press A or T while the Picture Size screen is open.
To select the picture size using the menus:
1 Select PictureSize in the Theater Settings menu.
Press 4 or I1_to select the desired picture size setting.
3 Highlight Done and press @.
Note: Some of the picture sizes may not be available
depending on the receiving signal format (those will be
"grayed out" in the Picture Size screen).
Using these functions to change the picture size (i.e.,
changing the height/width ratio) for any purpose other than
your private viewing may be prohibited under the Copyright
Laws of the United States and other countries, and may
subject you to civil and criminal liability.
Note: If you select one of the TheaterWidee) picture sizes, the
top and bottom edges of the picture (including subtitles or
captions) may be hidden. To view the hidden edges, either
scroll the picture (TheaterWide 2 and 3 only) or try viewing
the program in Full or Natural picture size.
39
To Next Page
Loading...
