Adjusting the audio
Muting the sound
Press M_Eon the remote control to partially reduce ( 1/2MUTE)
or turn off (MUTE) the sound. Each time you press M_E,the
mute mode will change in the following order:
112Mute _ Mute _ Volume _-==]
If the closed caption mode is set to Off when you select
"MUTE" mode, the closed caption feature is automatically
activated if the TV program is Closed Captioned. To mute
the audio without automatically activating the closed caption
feature, use _-_to set the volume to 0. See "Using the closed
caption mode" (_:_'page 43) for more information on closed
caption modes.
Usingthe digital audioselector
You can use the Digital Audio Selectorto conveniently switch
between audio tracks on a digital channel (for those channels
that have multiple audio tracks). This temporarily overrides
the audio track chosen by the language option under Audio
Setup (c_, "Selecting stereo/SAP broadcasts" on page 44).
To use the digital audio selector:
1 Dr ss=_Nu
e_ o and open the Audio menu.
2 Highlight Digital Audio Selector and press @.
Audio Settings ...............................................
.....Advanced Audio Settings
3 Press A or T to select Audio, and then press 4 or _ to
select the desired service.
4 Pr ss EX,T
e_ O.
Selectingstereo/SAPbroadcasts
The multi-channel TV sound (MTS) feature allows you to
output high-fidelity stereo sound. MTS also can transmit a
second audio program (SAP) containing a second language,
music, or other audio information (when provided by
individual stations).
When the TV receives a stereo or SAP broadcast, the word
RECALL iS
"STEREO" or "SAP" appears on-screen when © _ pressed.
The MTS feature is only available for analog signals on the
ART/CABLEinput.
To listen to stereo sound:
1
2
3
4
Press M_uand open the Audiomenu.
Highlight AudioSetup and press @.
In the MIS field, select Stereo.
To save the new settings, highlight Done and press @.
To reset the settings to the factory defaults, highlight
Reset and press @.
Note:
* Youcan typically leave the TVin Stereo mode because
it will automaticallyoutput the type of sound being
broadcast (stereoor monaural).
* If the stereo sound is noisy, select Mono to reduce the
noise.
To listen to an alternate language on an ATSC digital
station (if available):
Highlight the Languagefield in step 3 above, and then press
4 or _ to select the language you prefer.
To listen to a second audio program on an analog
station (if available):
Select SAPin step 3 above.
Note:
• A second audio program (SAP) can be heard only on
those TV stations that offer it. For example, a station might
broadcast another language as a second audio program.
If you have SAP on, you will see the current program on the
screen but hear the other language instead of the program_
normal audio.
• Ifyou have ,gAP on and the station you are watching is
not broadcasting a second audio program, the station's
normal audio will be output. However, occasionally there is
no sound at all in SAP mode. If this happens, set the MTS
feature to Stereo mode.
44
To Next Page
Loading...
