12
Remote Control
Remote Control Operation Range
Installing Batteries in the Remote Control
NOTE: Check information according to the actual remote control in the
accessory bag.
1. Slide the back cover to open the battery compartment of the remote
control.
2. Insert two AAA size batteries. Make sure to match the (+) and ( - ) ends
of the batteries with the (+) and ( - ) ends indicated in the battery
compartment.
3. Close the battery compartment with the cover.
1 2
3
NOTE
• Product image is only for reference, and actual product may vary in
appearance.
Handling the Batteries
• Incorrect use of batteries may cause corrosion or battery leakage,
which could cause fire, personal injury or damage to property.
• Only use the battery type indicated in this manual.
• Do not mix old and new batteries or different types of batteries.
• Do not dispose of used batteries as domestic waste. Dispose of them
in accordance with local regulations.
• Battery chemicals can cause a rash. If the batteries leak, clean the
battery compartment with a cloth. If chemicals touch your skin, wash
immediately.
• If you do not intend to use the remote control for a long time, remove
the batteries.
• Remove depleted batteries immediately to prevent battery acid from
leaking into the battery compartment.
Pairing the Remote Control
Pair the remote to the TV after you power it on. Keep the remote control
within 3 metres from the TV. Press any button (except power and mic button)
to pair.
NOTE
• In special cases, press and hold button to pair.
• If an unknown error occurred with the remote, then it could have been
caused by interference. Try to remove what’s causing the interference
and pair it again.
• If an unknown error occurred in the remote control while the battery
power is normal, you can take out the batteries, press any key for 1~2
seconds, and insert them back. Then the remote control will work
normally.
• The remote cannot be paired to the TV while the TV is in standby mode.
To Next Page
Loading...
