English - 2 -
3
Connections
Antenna
Connect the antenna cable/s to your TV.
satellite
dish
aerial /
cable TV
External Devices
PLEASE ENSURE BOTH UNITS ARE
SWITCHED OFF BEFORE CONNECTING
Use the proper cable to connect two units together.
To select the desired input source, press the Source
button on the remote control.
HDMI connection
rear side or rear-left
side of TV
Power
After unpacking, allow the TV set to reach the ambient room temperature before you
connect the set to the mains. Plug one end (the two-hole plug) of the supplied detachable
power cord into the power cord inlet on the rear side of the TV. Then plug the other end
of the power cord into the mains socket outlet.
socket on.
IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.
Switching on the TV
4
In order to turn the TV on from standby mode:
Press the Standby button on the remote control
Press the control button on the TV
Internet connection
5
You can set up your TV so that it can access the Internet through your local area network (LAN) using a wired
or wireless connection. Refer to full user manual for detailed instructions.
Wired
modem/router
Wireless
wireless
modem/router
Note: The gures are for representation only
To Next Page
Loading...
Need help?
General