Need help?Do you have a question about the Toshiba Black Pear and is the answer not in the manual?
General| Brand | Toshiba |
|---|---|
| Model | Black Pear |
| Category | Recording Equipment |
| Language | English |
Describes the Black Pear units with and without a display.
Details the included USB cable, Ethernet cable, and DIN-rail clips.
Covers electrical safety, wiring regulations, and secure connections.
Instructions for setting up the unit using free configuration software.
Details hardware variants and models with different protocol solutions.
Specifies the required 24v AC supply and fuse rating.
Instructions for connecting to the Toshiba TCC-LINK network.
Explains RS232 and 2-wire RS485 connections and configurations.
Describes the 'Global Forced Off' signal function for the digital input.
Details the use of USB for configuration and firmware upgrades.
Covers Ethernet connection, auto-negotiation, and IP address configuration.
Diagram illustrating unit addressing and system configuration.
Explains how to set up systems, lines, addresses, and group units.
Defines master and slave units within a group and their command capabilities.
Details the function of navigation buttons and status indicator LEDs.
Visual representation of the menu structure and navigation flow.
Describes the main menu display, status indicators, and network information.
Explains the grid display of discovered units and their status indicators.
Shows how to view detailed status of individual fan coil units.
Details RS232/RS485 and Ethernet port configurations for Modbus.
Explains Modbus slaves, registers, and examples for HVAC data.
Covers specific registers for HVAC network status and system force off.
Lists settable parameters for HVAC units and their valid values.
Provides a comprehensive table of Modbus slave addresses and offsets.
Details the startup sequence and data transfer process for Trend interface.
Explains the configuration of Trend IQx outstations for HVAC parameters.
Refers to parameter settings for the Trend interface, referencing Section 7.4.
Lists supported BACnet object types for the interface.
Details the supported BACnet services for communication.
Provides a comprehensive list of BACnet objects and their properties.
Defines the naming conventions for BACnet objects.
Describes system-level objects for HVAC network status and force off.
Details the procedure and levels for restoring factory default settings.
Explains how to enter bootloader mode for firmware updates.
Lists settings restored for Trend interfaces upon reset.
Lists settings restored for BACnet interfaces upon reset.
To Next Page
