Need help?Do you have a question about the Toshiba TCB-IFMB641TLE and is the answer not in the manual?
General| Brand | Toshiba |
|---|---|
| Model | TCB-IFMB641TLE |
| Category | Recording Equipment |
| Language | English |
Explains warning and caution indications, including definitions for serious bodily harm and property damage.
Details the meaning of symbols used in the manual, such as prohibited items and compulsory items.
Outlines the purpose, functions, and technical specifications of the Modbus Interface.
Provides a diagram illustrating the physical dimensions and external appearance of the Modbus Interface.
Describes various methods for mounting the Modbus Interface unit, including surface and wall mounts.
Lists unsuitable locations for installing the Modbus Interface to prevent damage or malfunction.
Specifies the necessary clearance around the unit for cable connection and maintenance access.
Details how to connect power, earth, and communication cables to the specified terminals on the terminal block.
Instructions on attaching clamp filters to communication cables for noise reduction.
Provides an example of wiring connections for multiple Modbus Interface units.
Explains how to set terminator resistors for RS-485 and TCC-LINK connections.
Details the procedures for earthing shielded communication cables for safety and proper function.
Describes how to set unique addresses for multiple Modbus Interface units using SW1.
Explains the function of the SW2 switch for testing and delayed response modes.
Details SW3's function for switching specifications and RS-485 baud rates.
Describes the function of the SW4 switch for testing purposes.
How to select the RS-485 terminator resistor using SW5.
How to select the TCC-LINK terminator resistor using SW6.
Explains the function of the SW7 reset switch for applying settings.
Pre-test checks to ensure proper setup, including address settings and reset switch activation.
Procedure for performing the operational test and verifying communication status using LEDs.
Explains how LED5 indicates communication status with indoor units during testing.
Provides a table mapping central control addresses to SW1/SW2 settings for test runs.
Details how LED5 displays communication status with the Modbus Master during testing.
Lists and describes the function of LEDs (LED1-LED5) during normal operation.
Instructions for installing the TCB-IFMB641TLE unit as a replacement for the TCB-IFMB640TLE.
Guidance on setting the RS-485 baud rate and address switches for the TCB-IFMB641TLE.
How to switch between TCB-IFMB641TLE and TCB-IFMB640TLE variable specifications.
To Next Page
