User’s Manual 6-8
Power and Power-Up Modes
Removing the battery pack
To remove a discharged battery, follow the steps as detailed below:
1. Save your work.
2. Turn the computer's power off - ensure that the Power indicator is off.
3. Remove all cables and peripherals that are connected to the computer.
4. Close the display panel and turn the computer upside down.
5. Slide the battery lock (1) into its ( ) position.
6. Slide and hold the battery release latch (2) to disengage the battery
pack and then remove it from the computer (3).
Releasing the battery pack
Installing the battery pack
To install a battery pack, follow the steps as detailed below:
1. Insert the battery pack as far as it will go into the computer.
2. Ensure that the battery pack is securely in place and the battery lock is
in its locked position.
3. Turn your computer over.
Password Utility
The password utility allows you to maintain an additional level of security
and provides two levels of password security: User and Supervisor.
1. Battery lock 3. Battery pack
2. Battery release latch
3
1
1
2
3
1
2
Do not touch the battery release latch while holding the computer or the
battery pack might fall out due to the unintentional release of the battery
release latch and cause injuries.
Passwords set in TOSHIBA Supervisor Password Utility are different from
the Windows
®
login password.
To Next Page
Loading...
Need help?
General
