– 106 –
No.
j
k
Part name
PMV coil
Fan guard
Procedure
1. Detachment
1) Perform work of Detachment 1 of
c
and
e
.
2) Take off screws that fix the wiring division panel and
the side cabinet. (M4, 8 mm, 2 pcs.)
3) Turn the coil while pulling upward and then remove
the coil from the PMV main unit.
2. Attachment
1) Surely match the positioning projection of the coil with
the concave part of PMV main unit and then fix it.
1. Detachment
1) Perform work of Detachment 1 of
c
and
d
.
XREQUIREMENTX
To prevent scratch on the product, carry out the work
on cardboard, cloth, etc.
2) Remove the discharge port cabinet and then put on
it so that the fan guard side directs downward.
3) Remove the guard stopper. (8 positions × 2)
2. Attachment
1) Insert the guard stopper to fix the fan guard.
(8 positions × 2)
XREQUIREMENTX
Check that all the guard stopper are fixed at the
specified positions.
Remarks
Hooking claw
To Next Page
Loading...
