– 84 –
No.
d
Part name
Front cabinet
Procedure
1. Detachment
1) Perform work of Detachment 1 of
c
.
2) Remove screws (M4, 8 mm, 2 pcs.) of the front
cabinet and the inverter cover.
3) Take off screws of the front cabinet and the
bottom plate. (M4, 8 mm, 3 pcs.)
4) Take off screws of the front cabinet and the motor
support. (M4, 8 mm, 2 pcs.)
5) Take off screws of the front cabinet and side
cabinet (Right). (M4, 8 mm, 1 pc.)
• The left side of the front side if made to insert to
the rear cabinet, so remove it pulling upward.
2. Attachment
1) Insert hook at the left side of the front side into
the rear cabinet.
2) Hook the lower part at the right side of the front to
concavity of the bottom plate. Insert the hook of
the rear cabinet into the slit of the front cabinet.
3) Attach the removed screws to the original positions.
Remarks
1) Perform works of Detachment 1 of
c
and
d
.
2) Take off screw of the side cabinet (Right) and the
heat exchanger. (M4, 8 mm, 1 pc.)
3) Take off fixed screws between the main unit and the
inverter box. (Wiring port side) (M4, 8 mm, 2 pcs.)
4) Take off screws of the side cabinet (Right) and the
bottom plate. (M4, 8 mm, 2 pcs.)
5) Take off screw of the side cabinet (Right) and the
valve fixed plate. (M4, 8 mm, 1 pc.)
Side cabinet
(Right)
e
Motor support
To Next Page
Loading...
