Unblocking programs temporarily
1 If you try to watch a TV program that exceeds the rating
limits you set, the TV will enter into the program block
mode.
THIS pROGRAM HAS BEEN BLOCKED
TV-PG L V
EXCEEDS 6ET LIMITS
PUSH MUTE TO ENTER PIN
CABL_
2 Ifyouwant to watch the blocked program temporafily,
press MOTE.
Press the Number
buttons (0-9) to enter the
4-digit code you have
stored.
If the number is correct, the
block mode will be
released.
After 1 second, normal
picture will appear.
BLOCKIN_I iS ACTIVE
PLEASE ENTER P]N C_OE
TO TEMP_[LY UN-BLO(_K
SELECT[0-9] END{EXIT]
All blocking is disabled until the TV is turned off.
It will be enabled when the power is reapplied.
lfa wrong pin code is
entered, the message
appears.
Enter the correct code
again.
INCOI_RECT PIN COOE
PLEASE ENTER PIN CODE
TO TEMFORARILY UN BLOCK
SELECT{O-g} ENDIEXIT]
BLOCK CHANNEL function
With the CHANNEL BLOCK function, you can block
specific channels. The TV will not be able to tune these
channels with the CHANNEL &/• buttons or Channel
Number buttons, unless you clear the setting.
This TV has 8 memory spaces total, 4 for TV mode and 4
for CABLE mode.
To block channels
1 Select a channel you want to block.
2 Select"BLOCK
CHANNEL" in the V-CHIP
CONTROL menu by
pressing • or &.
ET _,T I_O
SET BLOCKING OPTION,,
_iE_ ¸ pIN DO_E
BLOCK CHANNEL
_VE{ff ,I SELECTI4 _1
6L_K CHANNEL
[SET]CLEAR
0000
SELECT[_ _] SET[V AI
E_[EXlT]
BL_K CHANNEL
ISET]CLEAR
0002
END(EXITI
3 Press • or It, to display the
BLOCK CHANNEL menu.
4 Press • or • to select
"SET", then press • or •
until the channel number to
be blocked ("2" in this
example) replaces "0" on
the display.
5 Repeat steps 1 to 4 for other channels.
6 SelectanotherchannelbeforeturningofftheTV.
To restore channels
I Select "CLEAR" following the
above steps 2 to 4.
2 Press • or • until "0"
replaces the channel
numbers.
8L_K CHANNEL
SET [CLEARI
/
SELECT[< • ]1 ;LEAR[lf • I
ENDIEXIT I
1
0 _ 0 0
3 Press EXIT to erase the display.
33
To Next Page
Loading...
Need help?
General
