Plug the aerial directly into the AERIAL INPUT on the
television set. Ensure all other products are in standby
before continuing.
Connect the television to the mains, the red LED will light
up. The DIGITAL Welcome screen will appear, this may
take a few moments. If the screen does not appear press
the standby button on the remote control.
To start auto tuning press OK.
The AUTO TUNING screen will appear and
the television will start to search for available
stations. The progress bar will move along
the line.
You must allow the television to complete
the search.
When the search is complete the television will
autmatically select programme one. The
AUTO TUNING screen will display all the
services found.
Press OK to continue.
DIGITAL Auto tuning is now complete.
To select programmes press the number buttons.
NOTE: ANALOGUE Quick Setup will need to
be run to tune in the analogue stations.
For details of this, programme sorting and further
operations plus equipment connections please
refer to the TV Owner’s Manual.
Auto Tune – WLT68
Quick Set Up Guide and Remote Control
TOSHIBA
1
2
3
4
Thank you for choosing this Toshiba television.
First you need to tune in your television. Please
ensure aerial is connected before proceeding.
Press to continue
EXIT
Cancel
AUTO TUNING
Progress
Prog. Name Type UHF Quality
70 CBBC Channel 34 Good
87 Community 21 Poor
Change Watch
Page Up Page Down Sort
AUTO TUNING
88 programmes found
55 TV 25 Radio 8 Text
Press OK to watch programme
Prog. Name Type UHF Quality
1 BBC ONE 34 Good
2 BBC TWO 34 Good
3 ITV1 31 Good
4 Channel 4 31 Poor
5 five 48 Good
6 ITV2 31 Poor
To Previous Page
Loading...
