Toshiba D-RW2SU/D-RW2SC - Page 40

40
Basic Setup
EN
Setting the clock (cont’d)
Notes
• The clock may set itself automatically after you connect the antenna/cable signal to this unit and plug in the
power cord. In this case, the current time will appear on the front panel display.
• If the current time is not displayed or the displayed clock is not correct, set the clock manually.
5
Press [SETUP] to exit.
6
Press [I/
y
ON/STANDBY] to turn off the unit.
This unit will search for the time only when the power is off.
Leave it off for several minutes to give this unit time to set the
clock on the front panel display.
BasicsetupCD.indd40BasicsetupCD.indd40 2006/02/1620:57:462006/02/1620:57:46