38 EN38 EN
BASIC RECORDING & ONE-TOUCH TIMER RECORDING
7
Press [STOP C] to stop recording.
The recorded title will be included in the title list.
(Refer to “Guide to a Title List” on page 71.)
e.g.) DVD+R/DVD-RW/-R
Wait for a moment 90%
This operation may take
awhile to be completed.
6
Press [REC I] to start recording.
“I” will be displayed for 5 seconds.
I
SP 1:53
Press [PAUSE F] to pause recording.
Press [PAUSE F]] or [REC I] again to restart
recording.
To set one-touch timer recording (OTR)...
This is a simple way to set the recording time in blocks
of 30 minutes.
Press [REC I] repeatedly until the desired recording
time (30 minutes to 8 hours) appears on the TV screen.
One-touch timer recording will start.
0:30
(normal recording)
8:00 7:30
1:00
I
0:30
• To change the recording length during one-touch
timer recording, press [REC I] repeatedly until the
desired length appears.
• To cancel one-touch timer recording within the
specified time, press [STOP C].
Note
• When you press [REC I], recording starts immediately and continues until the disc is full or you stop recording.
• When the unit clock has not been set, the space for a date and time of title names will be blank.
• You cannot change the recording mode during the recording pause mode.
Note for one-touch timer recording
• The remaining recording time will be displayed on the front panel display during one-touch timer recording. Press
[DISPLAY] to see it on the TV screen.
• Unlike the timer recording, you can perform the following operations during one-touch timer recording.
- Turning the unit into the standby mode (One-touch timer recording will be canceled.).
- Using [REC I] or [STOP C] on the remote control.
• You cannot use the pause function during one-touch timer recording.
• If DVD one-touch timer recording is completed during VCR playback or recording, the DVD will be in stop mode
and the VCR keeps the current mode.
• When one-touch timer recording is finished and the power is turned into the standby mode, the unit will switch to
the timer-standby mode automatically if a timer recording has been programmed. Press [TIMER SET] to cancel
the timer-standby mode to use the unit continuously.
E9PKBUD_DKVR60KU_EN.indd 38E9PKBUD_DKVR60KU_EN.indd 38 8/11/2009 4:00:30 PM8/11/2009 4:00:30 PM
To Next Page
Loading...
Need help?
General
