4.EDITING FUNCTIONS
Image Editing 107
4 EDITING FUNCTIONS
6
Key in the read values.
1) Press [X1], [X2], [Y1] and [Y2], and then key in the read values correspondingly.
2) You can specify up to 4 areas on 1 page. When you want to specify more than one area, press
[AREA 1] to [AREA 4] to switch the area, and then key in the values correspondingly.
3) Press [OK] after you have specified all the areas.
8
Select other copy modes as required, and then press the [START] button on the control
panel.
7
Place the original again on the original glass with its
face down.
Place it with its bottom toward you. Align its top left corner
against that of the original glass.
To Next Page
Loading...
