Toshiba e-Studio 332s - Procedure for Scan to Local PC

- 94 -
Scanning to Local PC
4
Scanning
Procedure for Scan to Local PC
This section explains how to start Scan to Local
PC. The following procedure is common for
Windows and Mac OS X.
You need to congure the initial settings before
using the Scan to Local PC function.
Select the connection method and follow each
procedure.
● “For Network Connection” P.94
● “For USB Connection” P.95
● “For WSD Scan Connection (Windows only)”
P.96
 For Network Connection
Note
● For Mac OS X 10.7, if you scan documents through
network connection, you need to start the Image Capture
rst. Then, you need to select the machine from the list
displayed at the left of Image Capture screen.
1 Press the <SCAN> key on the operator
panel.
2 Place your document in the ADF or on
the document glass as below:
● ADF
Load documents face up with the top edge of the
documents in rst.
Adjust the document guides to the width of your
documents.
● Document Glass
Place the document face down and align its top
edge to the upper-left corner of the glass.
Close the document glass cover gently.
Note
● Do not apply an excessive load to the document
glass.
Memo
● The machine prioritizes the ADF when scanning
documents. Be sure not to place documents on the
ADF when you use the document glass.
3 Press the to select [Local PC] and
then press
OK
.
4 Check that [Select A Connecting PC]
is selected and then press
OK
.
5 Check that [From Network] is selected
and then press
OK
.
6 Press the to select the computer you
want and then press
OK
.
7 Press the to select [Select An
Application] and then press
OK
.