5.SAVING COPIED DATA AS A FILE
124 Copying and Saving as a File
Setting share folder
When a user who has the privilege of setting a share folder has pressed [Remote 1] or [Remote 2], the menu for
specifying a directory appears.
The setting items differ depending on the file transfer protocol to be used. FTP, SMB, NetWare IPX/SPX, NetWare TCP/
IP and FTPS are selectable for a file transfer protocol.
FTP / FTPS
When you press any of the buttons below, the on-screen keyboard appears. When you finish the entry, press [OK].
Server Name: Press this to enter the IP address of FTP server. For example, if the data should be transferred to an
FTP folder ftp://10.10.70.101/user01/scan/, key in “10.10.70.101”.
Network Path: Press this to enter a network path to an FTP folder where the data are to be stored. For example, if
the data should be transferred to an FTP folder ftp://10.10.70.101/user01/scan/, enter “user01\scan”.
Login User Name: Press this to enter a user name to login to the FTP server. Enter this as required.
Password: Press this to enter a password to login to the FTP server. Enter this as required.
Command Port: Press this to key in a command port number for executing commands. Normally “-” is entered in
this field, which means that a port number set by the administrator will be used. Change this only when you want to
use any other port number.
To Next Page
Loading...
