1
2
3
4
5
Description of Each Component
13
Left side / Inner side
1. Platen sheet
&P.60 “Regular Maintenance”
2. Original glass
Use this to copy three-dimensional originals, book-type
originals and special paper such as OHP lm or tracing
paper, as well as plain paper.
3. Bridge unit
Open it when paper jams occur.
4. Waste toner box
&P.45 “Replacing Waste Toner Box”
5. USB port
Use this port when printing les stored in a USB device or
storing scanned data into the USB device.
6. Receiving tray
Printed paper exits into this tray. The loading capacity is
approx. 100 sheets (80g/m
2
or 20 lb. Bond). This may vary
depending on the paper conditions such as the degree of
paper curling.
7. Scanning area
The data of originals transported from the Reversing
Automatic Document Feeder are scanned here.
&P.60 “Regular Maintenance”
8. Original scale
Use this to check the size of an original placed on the
original glass.
9. Touch panel
Use this to set and operate various types of functions such
as copying and fax.
&P.19 “Touch panel”
10. Control panel
Use this to set and operate various types of functions such
as copying and fax.
&P.16 “Control panel”
11. Control panel arm
Use this to adjust the height of the control panel.
&P.18 “Adjustment of the height and angle of the control
panel”
12. Black toner cartridge
13. Cyan toner cartridge
14. Magenta toner cartridge
15. Yellow toner cartridge
&P.44 “Replacing Toner Cartridge”
To Next Page
Loading...
