Toshiba E-studio 5520c - Optional Equipment Configuration

Chapter 1 PREPARATIONS
14
Conguration of options
3 4
2
1
1. Saddle Stitch Finisher (MJ-1104)
This Finisher enables saddle stitching, in addition to sort/
group nishing and stapling. The Hole Punch Unit
(optional, MJ-6102) can be installed in this Finisher.
2. Finisher (MJ-1103)
This Finisher enables sort/group nishing and stapling.
The Hole Punch Unit (optional, MJ-6102) can be installed
in this Finisher.
3. Hole Punch Unit (MJ-6102)
This unit enables you to punch holes on printed sheets.
4. External Large Capacity Feeder (MP-2501)
This feeder enables you to feed up to 2500 sheets (80 g/m
2
or 20 lb. Bond) of A4 or LT paper.
Other options available are as follows. Contact your service technician or Toshiba product distributors for details.
FAX Unit (GD-1270)
This is a unit for using the equipment as a Fax machine.
Installed inside of the equipment
2nd Line for FAX Unit (GD-1260)
This unit enables you to add a line to the Fax, making a 2nd line
available.
Installed inside of the equipment
The Fax Unit (optional, GD-1270) is required.
Wireless LAN Module (GN-1050)
This module enables the equipment to be used in a wireless LAN
environment.
Installed inside of the equipment
The Antenna (optional, GN-3010) is required.
The equipment cannot be connected to the wireless and wired
LAN at the same time.
•
•
•
•
•
•
Bluetooth Module (GN-2010)
This module enables you to perform Bluetooth printing.
Installed inside of the equipment
The Antenna (optional, GN-3010) is required.
Antenna (GN-3010)
This is used when the Wireless LAN Module or Bluetooth Module
is installed.
e-BRIDGE ID Gate (KP-2004, KP-2005)
You can login and use the equipment simply by holding the IC
card over the e-BRIDGE ID Gate.
Installed on the right-hand side of the equipment.
•
•
•