17
FAST—for good quality documents, without drawings
or small details
NORMAL—for documents with drawings or small char-
acters
QUALITY—for maximal resolution
Press OK.
5 Your e-STUDIO60F can reduce or magnify a spe-
cific part of a document from 25% to 400%. Set
the desired zoom value with the key pad and press
OK. ZOOMING
6 You can change the origin of the flatbed scanner
(by default, this is the back left angle of the scanner
window marked with arrows).
By entering new values of x and y given in millime-
tres, you will move the scanning zone as shown
on the figure below. Confirm the entries with
OK. ORIGIN
7 If the document is too light or too dark, you may
change the scanning contrast. Press / or O as
many times as necessary to choose the desired
contrast, as shown by the position of the cursor.
Press OK. CONTRAST
8 You can adjust the saturation. Saturation is the col-
ourfulness judged in proportion to its brightness.
Use / to change the setting: - is more grey, + is
more saturated. Confirm with OK. SATURATION
9 If you have chosen colour copy, you can adjust the
RGB values. All colours can be defined as combi-
nations of red (R), green (G) and blue (B). You can
change the values for each of these basic colours
with /. Press OK. R.G.B.
10 You can adjust the luminosity (brightness) of the
printer. Use / to change the setting: - is darker, +
is lighter. Press OK. LUMINOSITY
11 Use / to set whether you use plain, coated,
or photo paper, or transparent film and press
OK. »PLAIN PAPER
To Next Page
Loading...
