1.LOADING PAPER
Doing Paper Settings 19
LOADING PAPER
Attribute
*1 Fax transmission and reception is available only when the FAX Unit is installed.
*2 When lists are printed, paper set as “Fax” is used. For printing lists, refer to the MFP Management Guide.
*3 When “Rotate Sort” is turned ON for Rx printing in the Fax menu, “Fax” cannot be set for attribute. For how to set Rx printing, refer to the
GD-1370 Fax Guide.
If you select a wrong paper type, this could cause a paper misfeed or significant image trouble.
If paper cannot be fed, printing takes a long time after feeding or the quality is poor, turn over the paper and place
it again as shown in the figure or place fewer sheets.
The thickness and attribute can be set together.
When the thickness “Thick” or “Thick 1, 2 or 3”, or an attribute other than “None” is set for a drawer, the paper
placed in this drawer will not be used for the automatic paper selection mode.
When an attribute other than “None” is set for a drawer, the Automatic Change of Paper Source function (Feeding
the same size of paper from a different drawer even if the specified drawer from which paper is being fed is empty)
is disabled for the paper in this drawer.
For how to set Automatic Change of Paper Source, refer to the MFP Management Guide.
Icon Thickness Description
— None No attribute specified
,
Insert Sheets used in the sheet insertion mode
To learn how to use the sheet insertion mode, refer to the Copying Guide.
Up to 2 types of sheets (Insertion sheets 1 and 2) can be set. To set Insertion
sheet 1 and 2, select the drawer for Insertion sheet 1 and press [Insert], and
then select a drawer for Insertion sheet 2 and press [Insert].
Cover Sheets used in the cover sheet mode
To learn how to use the cover sheet mode, refer to the Copying Guide.
Special Colored paper or paper with watermarks, etc.
Fax
*1, *2, *3
Fax paper
1 Side Only 1-sided copy allowed
Black Only black and white copy allowed
1 Side Black Only 1-sided black and white copy allowed
To Next Page
Loading...
