1.LOADING PAPER
26 Loading Paper on the Bypass Tray
3
Hold the knob and align the side guides to the length of the envelope.
4
Check that there is no gap between the paper and the side guides.
If the gap is too wide, it could cause paper misfeeding, or the paper size could not be correctly detected.
Between the paper and side guides (“A” in the figure):
Make sure there is no gap. (0.5 mm (0.02") or less on one side, 1.0 mm (0.04") or less in total) However, if paper
misfeeding occurs, make a gap.
5
Select the bypass tray during the operation for copying or printing and specify the paper size and
thickness.
For details for the operation for copying or printing, refer to the Copying Guide or Printing Guide.
To Next Page
Loading...
