4.USING IMAGE ADJUSTMENT FUNCTIONS
Applying Twin Color Copying (Color Model only) 113
USING IMAGE ADJUSTMENT FUNCTIONS
3
Select a color for the black part in the original.
Press [Change Black To], and select the desired color.
4
Select a color for the parts other than black in the original.
Press [Second Color], and select the desired color.
After selecting the color, press [OK]. This is the end of the setting.
If you want to adjust the color balance, press [Adjust] and go to the next step.
When the two colors specified are the combination of black and a color other than black, color balance
adjustment is enabled. When neither of the two colors is black, or when both of them are black, this
adjustment is disabled.
The color balance of a color other than black can be adjusted.
5
Press or of the color to obtain the desired color balance.
After completing the adjustment, press [OK]. This is the end of the setting.
If you want to adjust each color balance on every density area, press [Detail] and go to the next step.
To Next Page
Loading...
