54 Selecting Finishing Mode
0.Selecting Finishing Mode
Finishing modes and optional finishing devices
See the table below for each finishing mode.
The available finishing modes differ depending on the type of optional finishing devices (Finisher and Hole Punch
Unit) installed. For which optional finishing devices can be used with this equipment, refer to the Specifications
Guide.
Finishing mode Description
Non-sort Non-staple Copies exit without being sorted or stapled.
Sort ( P.55) Copies exit in the offset mode (shift exiting) in the same page order as the
originals one set after another.
Group ( P.55) Copies grouped by page exit in the offset mode (shift exiting).
Rotate sort ( P.56) Copies exit in the offset mode (shift exiting) set by set alternately in a
different direction.
Staple sort ( P.57) Copies exit in the offset mode (shift exiting) with their corner stapled.
Magazine sort ( P.58) Copies exit in a book-type page order.
Center fold ( P.58) Copies exit in a book-type page order with their center folded.
Saddle stitch ( P.58) Copies exit in a book-type page order with their center folded and stapled.
Magazine sort & center fold (
P.58)
Magazine sort and center fold are used together.
Magazine sort & saddle stitch
( P.58)
Magazine sort and saddle stitch are used together.
Hole punch ( P.61) Copies exit with their side punched.
Manual staple (Paper
Preparation Guide)
Copies are stapled manually.
To Next Page
Loading...
