© TOSHIBA TEC CORPORATION 2012 All Rights Reserved.
2
UNPACKING (1)
There is no difference in the unpacking and set-up procedures among
e-STUDIO206L/256/306/356/456.
They do not vary so much in accordance with the destinations, either. Therefore,
this chapter takes e-STUDIO356, which is destined for Europe, for the purpose
of illustration.
Prior to the setup of the e-STUDIO356, keep the following consumables at the ready:
- DEVELOPER MATERIAL - TONER CARTRIDGE - PLAIN PAPER
* Only for North America and Europe
Sub Menu
II-1. e-STUDIO206L/256/306/356/456
Notes:
1) Be sure to keep spaces of at least 80 cm (both left and right) and 10 cm (rear) around
the equipment so that copy operations can be performed easily.
2) Be sure to install the equipment near an electric outlet so that it is easily accessible.
3) * For Japan, install the ground wire first and then plug in the power cable. Then remove
the ground wire after the power cable is unplugged.
II. UNPACKING AND SETUP
To Next Page
Loading...
Need help?
General
