Toshiba e-STUDIO211 - Page 127

3
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO181/211
ADJUSTMENT
3 - 45
(4) Loosen the hinge screws at the front side.
Fig. 3-43
(5) Position the pins with the holes on the ADF
by moving it so that the pins fit into the holes
when the ADF is closed.
Fig. 3-44
(6) Tighten the left-hand hinge screw at the rear
side.
Fig. 3-45
(7) Install the bracket.
Fig. 3-46