6
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO181/211
FIRMWARE UPDATING
6 - 13
(9) When updating has started, USB communication data are displayed in the STATUS field, and a
bar indicating the updating status appears at the bottom of the window.
Fig. 6-20
(10) When the program data transmission is completed, the message window shown below appears
on your PC monitor. Click [OK] to finish displaying the status.
Fig. 6-21
(11) Click [Exit] in the Firmware Download window to finish updating.
Note:
The display on the control panel of the equipment during update is as follows; the status of the
equipment and the corresponding software are indicated by the LED.
• During the update:
LEDs “B” and “E” or LEDs “B” and “F” are lit.
• When correctly completed:
All the LEDs “A”, “B” and “C” blink.
• On an update error:
All the LEDs of D are lit.
Note:
If an error occurs, repeat the procedure from the first step to retry updating.
(12) Turn OFF the power of the equipment, and disconnect the USB cable.
D : Download error indication
E : "Program" data
F : "Function" data
A : USB communication
B : Data being written on RAM
C : Normally completed
To Next Page
Loading...
