3.PRINT FUNCTIONS
Setting up Print Options 87
3 PRINT FUNCTIONS
3) Manual Scale
Enter the scale manually to enlarge or reduce an image. The ratio can be set at between 25 and 400%.
If originals which include thin lines are printed when the zoom ratio is set, the line width may vary.
For detailed instructions on how to print with the [Manual Scale] setting, see the following page:
P.98 “Fitting images within paper size”
4) Paper Source
Selects a paper source to print a job in the most suitable paper size. The figure on the right indicates the
paper size set for each paper source. When you select a paper source, the chosen one is indicated with a
green square in the figure.
- Auto
— Automatically selects the paper set in this equipment according to the printed document size.
- Drawer 1 — Paper is fed from the Drawer 1.
- Drawer 2 — Paper is fed from the Drawer 2.
- Bypass Tray — Paper is fed from the Bypass Tray.
The selectable values vary depending on the devices installed in this equipment and their configuration
on the [Configuration] tab.
5) Paper Type
Sets the media type of the paper.
- Plain — Printing on plain paper.
- Thick — Printing on thick paper.
- Thick1 — Printing on thick 1 paper.
- Thick2 — Printing on thick 2 paper.
- Transparency — Printing on transparent sheets.
- Thin — Printing on the back side of thin paper.
When [Drawer 1] or [Drawer 2] is selected in the [Paper Source] box, only [Plain] can be chosen in
the [Paper Type] box.
When [Envelope] is selected in the [Print Paper Size] box, [Envelope] will be displayed and you
cannot change the paper type.
6) Number of Copies
Sets the number of printed copies. This can be set at between 1 and 999.
7) Orientation
Sets the paper printing direction.
- Portrait
— The document is printed in the portrait direction.
- Landscape — The document is printed in the landscape direction.
To Next Page
Loading...
