Toshiba FlashAir W-04 Series - User Manual

FlashAir™ Settings:
Internet pass thru mode
● This function is available on the FlashAir W-04, FlashAir W-03 and FlashAir W-02 series with card software
version F19BAW3AW2.00.02 or later.
Internet pass thru function enables the Internet connection using other access points through
FlashAir. By connecting to an access point that is connected to Internet, you will have the access
to Internet and FlashAir at the same time.
When you are on Internet pass thru mode, you can browse and download the data stored in
the FlashAir.
You do not have to change the network settings of smartphones or other Wi-Fi
®
capable devices
when you upload images downloaded from FlashAir to SNS.

Toshiba FlashAir W-04 Series Specifications

General

Category	Storage
Type	SDHC / SDXC
Wireless Standard	IEEE 802.11b/g/n
Speed Class	Class 10
UHS Speed Class	UHS-I
Read Speed	Up to 90 MB/s
Write Speed	Up to 70 MB/s
Dimensions	32mm x 24mm x 2.1mm
Weight	Approx. 2 g
Operating Voltage	3.3V
Model	FlashAir W-04
Capacity	32GB / 64GB
Interface	SD Interface
Wireless Security	WEP, WPA, WPA2
Storage Temperature	-40°C to 85°C
SD Standard	SD 3.0
File System	FAT32

Summary

FlashAir Settings

Internet Pass Thru Mode

Enables Internet connection via other access points, allowing simultaneous access to the Internet and FlashAir.

Internet Pass Thru Mode Setup

Using FlashAir App for iOS or Android

Step-by-step guide to configure Internet pass-thru mode via the FlashAir App on iOS and Android devices.

Using FlashAir Configuration Software

Instructions for setting up Internet pass-thru mode using the dedicated FlashAir configuration software.

Sharing Contents with SNS