8 Precautions for Wireless LAN/Bluetooth Adapter
USA – Federal Communications Commission (FCC)
Supplier’s Declaration of Conformity:
Wireless LAN/Bluetooth Module GN-4030
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Toshiba America Business Solutions, Inc.
25530 Commercentre Drive
Lake Forest, CA 92630
Tel: 949-462-6000
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Non-modification Statement:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This device has been tested and meets the FCC RF exposure guidelines. The maximum SAR value reported is 0.571 w/
kg.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Caution: Exposure to Radio Frequency Radiation.
To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be
maintained between the antenna of this device and all persons. This device must not be co-located or operating in
conjunction with any other antenna or transmitter.
Singapore Portion
Approved Countries/Regions for use for our Wireless LAN/Bluetooth
This equipment is approved to the radio standard by the specific countries/regions. Please ask your service technician
or representative.
To Next Page
Loading...
