2-7-3. Cylinder Ass’y Removal from Main Base
2-7-4. Head Brush & Holder FPC Removal
1)
Remove threef3) screws @ holding the main base and
the cylinder ass’y.
2) Lift the cylinder ass’y
Q
in the direction of arrow.
NOTE
:
Do
not touch the video heads during removal or.
installation.
@
THREE
SCREWS
1)
Remove
one(l)
screw @ and then lift the head brush
a.
2) Release the holder FPC tab holding the cylinder base @
in the direction of arrow. (Refer to detail drawing)
3) Disconnect the holder FPC @ from the cylinder base
0.
NOTE
:
When disconnecting the holder FPC @from the
j
cylinder base
0:
Take care not to disconnect the
FPC cable from the holder FPC
(The
FPC cable is
IF---
@ ONE SCREW
0
HEAD BRUSH
@
HOLDER FPC
@
CYLINDER BASE
HOLDER FPC TAB
Fig. 20 Cylinder Ass’y Removal from Main Base
J
I
<DETAIL : BOTTOM VIEW>
Fig. 21 Head Brush
&
Holder FPC Removal
2-15
To Next Page
Loading...
