Toshiba M-672 - Page 17

2-7-5. Cylinder Ass’y Removal from Cylinder Base
1) Remove three(3) screws 0 from the cylinder base @.
2) Lift the cylinder ass) @from the cylinder base (p in the
direction of arrow.
2-7-7. Motor Rotor & Cylinder Sub Ass’y
1) Make sure that phase matching holes of the motor rotor
81 the cylinder sub ass’y are aligned correctly as shown in
Fig. 16 (Refer to phase matching hole)
2) Reinstall the retainer lever ass’y @and secure with
m CYLINDER ASS’Y
two(2) screws.
@ TWO SCREWS
@ RETAINER
RUBBER ASS’Y
7
@ CYLINDER BASE
ppa THREE SCREWS
Fig. 22 Cylinder Ass’y Removal from Cylinder Base
2-7-6. Motor Rotor Removal
1) Remove two(2) screws 0.
2) Lift the retainer lever ass’y @ and the motor rotor @
@ TWO SCREWS
@ RETAINER
RUBBER ASS’Y
MOTOR - ROTOR
@ CYLINDER SUB ASS’Y
@ MOTOR - ROTOR
PHASE MATCHING
- HOLE
SUB ASS’Y
Fig. 24 Assembly of Motor Rotor & Cylinder Sub Ass’y
2-7-8. Motor Stator Removal
1) Remove three(3) screws @).
2) Remove the motor stator a from the cylinder sub
ass’y Q.
@ THREE SCREWS
@ MOTOR - STATOR
@ CYLINDER SUB ASSY
Fig. 25 Motor Stator Removal
2-l 6
Fig. 23 Motor Rotor Removal