Toshiba M-672 - Page 19

2-8-3. Brake Sub “L” Removal
2-8-5. Reel Disk ‘I” Ass’y & Gear Relay “s”
Ass’y Removal
1) Remove the spring brake sub ‘L’ a.
2) Release the tab Q) in the direction of arrow.
(Refer to detail drawing)
3) Lift the brake sub ‘L 0.
r7-
@ SPRING-BRAKE SUB ‘L.
@ BRAKE-SUB ‘L”
@ TAB
@ BRAKE-SUB “L”
<DETAIL>
Fig. 29 Brake Sub ‘L’ Removal
2-8-4. Arm Tension Full Ass’y Removal
1) Remove the spring tension 0.
2) Release the tab Q in the direction of arrow.
(Refer to detail drawing)
3) Lift the arm tension full ass’y 0.
@ SPRING-TENSION
@ ARM-TENSION
FULL ASS’Y
@ ARM-TENSION
1) Release the tab (J) in the direction of arrow.
(Refer to detail drawing)
2) Lift the reel disk ‘L ass’y a.
3) Remove the washer plain a.
4) Remove the washer slit @.
5) Lift the gear relay ‘S’ ass’y a.
NOTE : When reinstalling, be sure to install the reel disk
‘L’ ass’y QI after installing the washer plain @.
@ REEL-DISK ‘L
ASSY
@I WASHER-PLAIN
@WASHER-SLIT
@ REEL-DISK “L’ ASSY
Q) TAB
I
<DETAIL>
Fig. 31 ReeL Disk ‘L’ Ass’y & Gear Relay ‘S’ Ass’y
Removal
Fig. 30 Arm Tension Full Ass’y Removal
2-18