Toshiba MD9DM1R - Page 17

DISASSEMBLY INSTRUCTIONS
B1-2
1-5: FRONT TRAY PLATE/TOP SHIELD
(Refer to Fig. 1-5)
1.
2.
3.
4.
Fig. 1-6
Unlock the 2 supports 1.
Remove the Front Tray Plate in the direction of arrow (A).
Remove the 13 screws 2.
Remove the Top Shield in the direction of arrow (B).
Front Tray Plate
Fig. 1-5
1-6: AV PCB/DVD PCB/CD DECK (Refer to Fig. 1-6)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
(B)
(A)
1
1
Top Shield
2
2
2
2
2
2
2
2
2
2
2
2
2
Make the short circuit on the position as shown Fig. 1-6
using a soldering. If you remove the Deck CD with no
soldering, the Laser may be damaged.
Remove the screw 1.
Remove the Bush Holder in the direction of arrow (A).
Remove the 2 screws 2.
Remove the AV PCB in the direction of arrow (B).
Disconnect the following connectors:
(CP8001 and CP8002).
Remove the 4 screws 3.
Remove the Angle Deck in the direction of arrow (C).
Disconnect the following connectors:
(CP2301, CP2302 and CP2601).
Remove the 4 screws 4.
Remove the CD Deck in the direction of arrow (D).
Remove the 4 screws 5.
Remove the DVD PCB in the direction of arrow (E).
DVD Block
When the installation of the Deck CD, remove all the
soldering on the short circuit position after the connection of
Pick Up PCB and DVD PCB connector.
NOTE
3
3
3
3
Angle Deck
(B)
(C)
5
5
5
DVD PCB
5
(E)
(D)
AV PCB
1
Bush Holder
2
2
Bottom Plate
(A)
4
4
4
4
CD Deck
Make the sort circuit
using a soldering.
Pick Up PCB