Toshiba MD9DM1R - Removal of Deflection Yoke

B2-2
DISASSEMBLY INSTRUCTIONS
4. Insert one end of the Anode Support into the anode button,
then the other as shown in Fig. 2-5.
Support
CRT
Fig. 2-5
5.
6.
Confirm that the Support is securely connected.
Put on the Rubber Cap without moving any parts.
3. REMOVAL OF DEFLECTION YOKE
(Refer to Fig. 3-1)
1.
2.
3.
4.
Loosen the screw 1.
Remove the Convergence • Purity Magnet in the
direction of arrow.
Remove the 3 Wedges.
Remove the Deflection Yoke in the direction of arrow.
INSTALLATION
Convergence •
Purity Magnet
Deflection Yoke
Wedge
Install new Deflection Yoke in reverse steps of REMOVAL.
NOTE
After adjusting the purity and the convergence, fix the
screw 1 and lock the wedges.
Fig. 3-1
Wedge
(A)
1