User’s Manual 5-4
The Keyboard
Suspend: Pressing FN + F3 switches the system to Suspend mode (Only
active when enable Suspend in Power Manager).
Hibernate: Pressing FN + F4 switches the system to Hibernation mode
(Only active when enable Hibernate in Power Manager).
Output: Pressing FN + F5 changes the active display device.
Brightness (Down): Pressing FN + F6 decreases the computer's display
panel brightness in individual steps.
Brightness (Up): Pressing FN + F7 increases the computer's display
panel brightness in individual steps.
Wireless: Pressing FN + F8 switches the following conditions.
It should be support the following condition:
1. Enable Bluetooth only (some models)
2. Enable Wireless only
3. Enable all device
4. Disable all device
■ If no wireless communication device is installed, no dialog box will
appear.
■ This hot key is available only when the wireless communication is set
to enabled in BIOS Setup.
To Next Page
Loading...
