User’s Manual 6-9
Power and Power-Up Modes
3. Remove all cables and peripherals that are connected to the computer.
4. Close the display panel and turn the computer upside down.
5. Slide the battery lock (1) into its ( ) position.
6. Slide and hold the battery release latch (2) to disengage the battery
pack and then remove it from the computer (3).
Releasing the battery pack (PORTÉGÉ R600)
Installing the battery pack
To install a battery pack, follow the steps as detailed below:
1. Insert the battery pack as far as it will go into the computer (1).
2. Ensure that the battery pack is securely in place and the battery lock (2)
is in its ( ) position.
Securing the battery pack (PORTÉGÉ R600)
3. Turn your computer over.
Battery pack
Battery release
latch
Battery lock
Do not touch the battery release latch while holding the computer or the
battery pack might fall out due to the unintentional release of the battery
release latch and cause injuries.
Battery pack
Battery lock
To Next Page
Loading...
Need help?
General